Comparison of the effects of different types of tube inserts on two-phase flow instabilities
Özet
Turbulence promoting inner elements such as rings, wings or winglets, twisted tapes, etc., is widely used in single- and two-phase flows. In this experimental work, the two-phase flow instabilities of forced convection boiling in a horizontal tube with ring- and twisted-tape-type inner elements inside are investigated. In order to analyze the two-phase flow of water, the experiments were conducted under a constant system pressure of 7.5 bar, and a constant heat input of 24 kW was applied to the outer surface of the circular test pipe with constant exit restriction. Three different inlet temperatures (Ti = 15, 25, and 35°C) were used to see the effect of inlet sub-cooling, and the mass flow rate was decreased from 110 to 20 g/s to obtain the characteristic curve. Two different pitch ratios for both the ring and twisted tape were evaluated in terms of stability. The results were evaluated in terms of appropriate variables for both the tube with insertions and the smooth tube. The analysis shows that the pressure drop increases with decreasing mass flow rate for all cases. The presence of the inner elements in the test pipe causes the boundaries of the oscillations to narrow in comparison with smooth tube. On the other hand, with the increase in the effective diameter of the test pipe the boundaries of the oscillations broaden. For each type of insertion, the increase of the pitch ratio makes the system less stable. © 2013 by Begell House, Inc.
Kaynak
Journal of Enhanced Heat TransferCilt
20Sayı
2Bağlantı
https://dx.doi.org/10.1615/JEnhHeatTransf.2013007708https://hdl.handle.net/20.500.12403/839
Koleksiyonlar
İlgili Öğeler
Başlık, yazar, küratör ve konuya göre gösterilen ilgili öğeler.
-
Optimization of RT superplasticity of UFG Zn-22Al alloy by applying ECAP at different temperatures and phase regions
Demirtas M.; Yanar H.; Purcek G. (Institute of Physics Publishing, 2017)Zn-22Al alloy was subjected to either one-step or two-step equal channel pressing (ECAP) to investigate the effect of processing temperature on its microstructure and room temperature (RT) superplasticity. In one-step ECAP ... -
Forced convective two phase flow analysis in a circular tube equipped with twisted tapes
Omeroglu G.; Comakli O.; Karagoz S.; Manay E. (2012)In forced convection boiling systems, it is important to know the dynamic behavior for understanding and predicting the local and global stability of the system. Besides this, the instability phenomenon in the industrial ... -
Separation and pre-concentration of palladium(II) from environmental and industrial samples by formation of a derivative of 1,2,4-triazole complex on Amberlite XAD-2010 resin
Serencam H.; Bulut V.N.; Tufekci M.; Gundogdu A.; Duran C.; Hamza S.; Soylak M. (2013)A simple separation/pre-concentration method was developed for extraction of Pd(II) in various environmental samples, based on its adsorption of 4-phenyl-5-{[(4-phenyl-5-pyridin-4-yl-4H-1,2,4-triazole-3-yl)thio]methyl}-4 ...