Yazar "Açikyildiz M." seçeneğine göre listele
Listeleniyor 1 - 3 / 3
Sayfa Başına Sonuç
Sıralama seçenekleri
Öğe Effect of temperature for the adsorption of methylene blue onto activated carbon produced from waste dogrose seeds(International Society for Horticultural Science, 2005) Gürses A.; Do?ar C.; Açikyildiz M.; Özkan E.; Bayrak R.Activated carbon, produced from dogrose (Rosa section Caninae) seeds, was used for the removal of methylene blue (basic dye). Adsorption studies were carried out at 20°C and 40°C at various initial dye concentrations (20, 40, 60, 80, and 100 mg/L) and at different lengths of time (15, 30, 60, and 120 min). Adsorption isotherms of the basic dye on the prepared adsorbent were determined and correlated with common isotherm equations. Fitting of the isotherm data to the BET adsorption isotherm model was better in high concentration ranges than in the other models. Thermodynamic parameters such as change in isosteric adsorption enthalpy (?H)y and isosteric adsorption entropy (?S)y were also determined to 40.8 kJ and 0.141 kJ, respectively. It was concluded that the adsorption of methylene blue increases with increasing temperature. BET model fitting indicates that the hydrophobic interactions between the dye and the produced active carbon at the first layer and the dipole-dipole interactions between methylene blue molecules and the adsorbed molecules at the secondary layer predominate. To investigate the adsorptive characteristics of the produced active carbon, porosity and BET surface area measurements were made. © ISHS 2005.Öğe Optimization of process parameters for removal of Cr(VI) by Hypnum cupressiforme using response surface methodology (RSM)(2012) Özkan E.; Gürses A.; Açikyildiz M.; Güneş K.Response surface methodology was applied to optimize the removal of chromium ion by Hypnum cupressiforme from an aqueous solution. Experiments were analyzed using response surface methodology (RSM). The biosorption process was investigated as a function of five independent factors, sorption time, sorption temperature, initial ion concentration, sorbent dosage, and mixing rate. The optimum conditions for the chromium biosorption were found to be 760 min, 313K, 30mg/L, 0.01 mg/100mL, 107 min-1 respectively, for sorption time, sorption temperature, initial ion concentration, sorbent dosage, and mixing rate. © by PSP.Öğe Thermodynamics and kinetic studies of biosorption of a basic dye from aqueous solution using green algae Ulothrix sp.(2010) Do?ar C.; Gürses A.; Açikyildiz M.; Özkan E.This study addresses removal of a basic dye, methylene blue, from aqueous solutions by using dried Ulothrix sp. biomass as biosorbent. The effects of the initial dye concentration, contact time, temperature, solution equilibrium pH, biosorbent dosage, and mixing rate on biosorption of the dye have been investigated. It was found that 30 min is sufficient in order to reach adsorption equilibrium. The amount of methylene blue adsorbed onto Ulothrix sp. increased with increasing equilibrium pH and mixing rate, in contrary, it decreased with increasing temperature and sorbent dosage. The process followed the pseudo-second-order kinetic model. The isosteric enthalpy and entropy values were calculated as -11.8 kJ/mol and 37.5 J/(mol K), respectively. In addition, the results suggest that the physical interactions between sorbent particles and sorbate ions play an important role for the adsorption of methylene blue onto the biosorbent. © 2009 Elsevier B.V. All rights reserved.
